HP P45647-001 rear cover is a replacement enclosure panel for the HP ProStudio 4 All-in-One G1i. HP’s service guide identifies this exact part number as the rear cover for that computer, making it a service component for restoring or replacing the system’s rear panel.
Removal begins after taking off the computer stand. The cover releases from a notch along its lower edge and around its perimeter, then lifts open to 90 degrees. A cable attached to the OSD board on the inside of the cover must be disconnected during removal, so the panel is connected to that assembly rather than being a loose external trim piece.
HP’s procedure reinstalls the cover by reversing the removal steps. This part is intended for service on the specified ProStudio all-in-one; the source does not establish package contents beyond the rear cover itself.